# Failed to load LMC Driver after lightburn

**URL:** <https://forum.lightburnsoftware.com/t/failed-to-load-lmc-driver-after-lightburn/71706>\
**Category:** Galvo\
**Tags:** ezcad2, delete-driver\
**Created:** [July 18, 2022, 5:36pm UTC](https://forum.lightburnsoftware.com/t/failed-to-load-lmc-driver-after-lightburn/71706 "2022-07-18T17:36:01Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![AFabTx](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/a/ee7513/32.png) [@AFabTx](https://forum.lightburnsoftware.com/u/AFabTx)\
**Post date:** [July 18, 2022, 5:36pm UTC](https://forum.lightburnsoftware.com/t/failed-to-load-lmc-driver-after-lightburn/71706/1 "2022-07-18T17:36:01Z")

</div>

I downloaded LB and ran the scan. Found the laser and i was unable to install using trial. I tried launching ezcad2 and it gives me the failed to load lmc driver. I bought the license so i could try to see if it would work. It does work but the etches are blurred. I cannot do the alignment because ezcad2 wont launch.

---

<div class="post-metadata">

**Author:** ![AFabTx](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/a/ee7513/32.png) [@AFabTx](https://forum.lightburnsoftware.com/u/AFabTx)\
**Post date:** [July 18, 2022, 7:39pm UTC](https://forum.lightburnsoftware.com/t/failed-to-load-lmc-driver-after-lightburn/71706/2 "2022-07-18T19:39:29Z")

</div>

Went in and deleted the drivers and it launched again.

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [August 17, 2022, 7:39pm UTC](https://forum.lightburnsoftware.com/t/failed-to-load-lmc-driver-after-lightburn/71706/3 "2022-08-17T19:39:54Z")

</div>

Closed on August 17, 2022, 7:39pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
