Im having trouble engraving photos onto wood. I preview my project on light burn before i run the project and everything looks good. But when I burn the image the photo turns out oblong. wider than it is tall.
parsec
December 8, 2024, 5:39am
2
Welcome to the starship.
Given one picture and four words, I think @JimNM has nailed it.
This test pattern helps identify mechanical problems:
GrundTest.lbrn2
Scale it to fit the platform and run it as fast as it will go in Line mode with optimizations turned off and power set to mark a sheet of cardboard. Any differences from the design will be informative.
Upload good photos of the result so we can look over your shoulder.
After post here the output.
system
January 7, 2025, 5:40am
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
