Finnaly cut my first jigsaw puzzle operating from Controller

Thanks for all your suggestions on cutting a jigsaw puzzle, operating from the controller. Today I managed to cut a jigsaw puzzle with engraved photo grabbed from the Internet. The actual engraving is not up to par, but the picture was of a couple strolling in the rain. Very cloudy day picture. Questions: Do you cut vertical first?
Mode=Atkinson
Cut=15/55
Image=300/30




1 Like

It’s unlikely that your machine is capable of an 0.080mm interval… most of the time, the beam diameter is larger, which limits resolution.

Is this an RF or glass tube? What lens are you using?

A good video on photo engraving was done by Laser Everything and is very good… If you haven’t watched it, you probably should :slight_smile:

:smile_cat: