Fire Button not firing

[BillBulloch (William D Bulloch)]

I have the Fire Button enabled in the Devise Settings and it is activated in the Move Window, but does not fire when pressed and will not fire to Frame the work. The laser will, however, fire when I Start the project. This is a new problem, it was working fine before. What did I do wrong?

[berainlb (PY)]

Take a look through this post and see if this addresses the issue.

Trazar limite de corte

Can you hear the fan start when you do frame with the shift key pressed? If so, you probably just need to raise your power level. [image] Raise that value until you can see the light. Make sure you are wearing eye protection. If you do not have the “Fire” button in the Move window, enable it in Device Settings. [image]

[BillBulloch (William D Bulloch)]

The Power Level was set to 0.5 and apparently that was too low. I increased it until it fired. Works now. Thanks for the replies; I always get the answers to my problems here on this forum.