Hiya maybe it’s already possible, but while doing a picture last week i lost connection, no biggi but wasted a sheet in doing so, could it not be possible to maybe engrave up from bottom, or down from top so if you lose connection, you could just change orientation and come up/down back to job, used this now and again in k40 Whisperer when it done the same thing, save’s a sheet and a heap of time, just an idea.
Ta 
change the scan angle to 180 and it should start from the top, allowing you to try to save your substrate.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.