Firmware to Sculpfun SF-A9 40W engraver

Hello, I have made an incorrect operation when configuring the WIFI of the Sculpfun SF-A9 40W and I have deleted the configuration of the machine, I need the firmware, for its installation with the Sculpfun Tools tool, in the WEB page of Sculpun the link to download the firmware does not work.

Thanks in advance

You can find the firmware here:

But how did you delete it? You can reset the configuration via console by sending $RST=*. That’s usually enough. There is no need to flash the firmware again, only in case of a boot loop.

1 Like