Fixing 1 1/4 of a engraved circle that didnt burn?

LightBurn Software Questions OS Specific
1

Is there a way to re engrave just a portion of your work. I have an emblem on a 6 inch circle?

If you cut the circle into 4 equal pieces, three of the 4 engraved perfectly while 1 qtr was really. Is there a way to tell the software/laser to only re-engrave the section that didnt come out good?

Any help is appreciated.

Thanks,
Tony

2

is it a picture, a vector, or multiple layers? There are ways to do it, but how you approach it will vary depending on the design.

3

Its a single layer picture.

Thanks,
Tony

4

You could apply a mask to the picture, and that would let you re-engrave only a part of it.

5

Thank You So Much. This worked and will be a HUGE help going forward.
Best Regards,
Tony

6

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.