Hi, im new to both software and hardware but giving it a go. Everytime i try to run my laser the bloody flame alarm goes off and even stops the laser in its tracks!! Its not particularly light where i am… I also tried putting the code in the console to disable but still goes off!!.. Im in tve UK if it makes a difference??
Welcome to the forum, the cause can be quite a few things. The search box is your friend. Check this thread out.
Too long didn’t read?
Ive searched and the only solution is to put in the code… Ive done that and it didnt dosable!!
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.