Hello,
I am running an Ortur LM2 Pro using version 1.0.6 of the Lightburn software. Up till version 1.0.3 the frame button would work perfectly. The laser would frame only the content that was on the output on the layers marked as output and show. I updated the Lightburn software to version 1.0.4 and the frmae button does not honor the layers marked as do not output and do not show. I uninstalled version 1.0.4 and went back to version 1.0.3 and now the frame button is still broke. I tried versions 1.0.5 and 1.0.6 and still the frame button is broke. I event went as far as updating the firmware on my laser and still does not frame correctly. I there a setting in the software I missing or is this just a change that broke the frame button.