Frequency engraving with ruida controller

LightBurn Hardware Compatibility Ruida controllers
1

Hi i would like to know how to set the frequency for engraving.

Now the engraving will be executed with the last set frequency, so when the last job was cutting at 1200Hz, the next (engraving) job will be done at 1200Hz, witch is much to low.
I can not find where to set the frequency in engraving settings.

Using Lightburn with Ruida and a RF laser.

Kind Regards, Marc

2

I believe in the current build there is a bug where you have to set the frequency in ‘Line’ mode, then change back to ‘Fill’ mode.

The next release of LightBurn (1.3.00) has the frequency setting available for all modes.

3

Thanks for the quick reply, i will wait for the next release.

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.