Gantry keeping limit switches pressed

on k40 when gantry is homed it hits switches and keeps them pressed should it come off switches like it did with m2 board if so what settings need set

Depends on which firmware you’re running on the Cohesion board. The settings for Smoothieware are different than those for GRBL. For Smoothieware they’re on the SD card on the board.

Please post your inquiry on the Cohesion3D Forum so that our support team can assist you.

i am running Smoothieware could you tell which settings need changed

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.