I started reusing my laser after a few months and am running into a small issue that I haven’t seen posted anywhere. When I click ‘get position’ the indicator jumps up to my origin (top right). However if I use the arrow buttons within lightburn to jog the laser head, the on screen indicator moves to the correct place and stays there until/if I click ‘get position’ again. I haven’t used lightburn and my laser since mid summer and I was running an older version LB before I updated it today, but I know that I used to be able to click get position and see on LB where the laser head was even if I jogged the head using the buttons on my laser cutter itself. Is there a way I can fix this? Or was this an update that I am going to have to get used to? Thanks for any and all help you can provide.
When the “Get Position” button on the Move tab is selected the crosshairs vanish. Using the arrow buttons to step the head in any direction causes it to reappear. Toggling Show Position has no effect. This is on a Rudia controller, 80 watt laser.