I just got a Enjoywood 20w (Atomstack 20) and was using the free trial for a few days with no problem. Now, it maybe will engrave a few lines, sometimes 3 or 4 minutes and just stop. I get the below log. I tried lasergrbl which works fine. I do not want to learn lasergrbl. Here is the log, if you ca…

Looks like a bad firmware. Do you get this messages after the crash or at the beginning? If it’s at the beginning, that doesn’t matter. If it happens during runtime, flash the firmware again.

I will do that. It does print perfectly with lasergrbl.

That’s a little weird, indeed. You can also try to toggle the “enable DTR signal” option in device settings, this also helps with communication problems sometimes. And disable gcode clustering in case it is turned on.

LightBurn Software Forum

Getting an error in lightburn

LightBurn Hardware Compatibility GRBL

grbl

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled