Getting the following error

LightBurn Software Questions
1

ALARM:2

G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)

On or near line 4:

2

2 suggestions:

  1. Make sure you’re not moving the laser head by hand after homing
  2. Suggest you use “Absolute Coords” as the “Start From” mode until you’re very familiar with your laser and LightBurn.
3

I am using the absolute cords and not moving the laser by hand.

4

In that case can you run these commands in Console and return output?

$H
$I
$$
$#
?

Note that the first command will home the machine so be prepared for that.

5

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.