GRBL 1.1 and travel speed

LightBurn Software Questions
1

Hi all,

Been using Lightburn for a short time but it is a great product.

I have a 3018PRO CNC that I have added a 7.5W blue diode laser to. Works great.

My question is, while I can of course set the mm/min for each burn layer the way I want, I have noticed the travel speed for non-burning moves are much higher than I like. Is there anyway to set these? I have not found anything that looks like these settings.

Jeff

2

I have a similar animal. I think you can set max speed in the $110 - $112 registers on the controller. These are max speed setting for your device.

:slight_smile:

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.