Have trouble engraving with my Trocen AWC controller

Having a little trouble with my a AWC controller and Engraving. All of these were engraved at 250 mm a second.
I’m using hybrid stepper Motors on a 1300 by 1000 mm bed.

  1. Is a single directional fill with scanning offset adjustment on, as you can see the engraving doesn’t go all the way to the left and right, if I move the scan offset anymore the Gap just appears to get bigger on the left.
  2. Bi-directional fill is turned on and scan offset is on, this gave me my first clue as to what could be going wrong in that the fill is correct on the left but way out of place on the right.
  3. Bi-directional fill is on, scan offset is off.

Run the same file on the Trocen-supplied software and see if you have the same problem.

What is the model number of the controller are you using?

AWC7813 is the model number.

Did you try what @Bonjour suggested? What was the result?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.