Have two lasers. both working fine as of two days ago

Have two lasers. Both working fine with lightburn until two days ago. They both do same thing. When I tell them to frame artwork the stepper kicks in but locks itself at home postion. Takes some effort to move gantry. I have an Ortur and Xtool D1 both been running well on lightburn until today. i used xtool software on thier laser and it runs fine. Got me puzzled. Help if you can is needed.Jim

Hi James, can you post a screenshot of what your LightBurn window looks like? Did you recently update or change any settings that may be the culprit?

Try changing to “Absolute Coords” mode in Start From: part of the Laser window and run your frame again.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.