Head jumps to Y=0 during scan


(Joseph Shawa) #1

The job seems to pause occasionally and the laser turns off while the head moves to the top of the table (y=0) then comes back immediately and resumes the scan. This is on that dxf I sent you earlier. I am scanning the RD works import of that dxf.
The line interval is set for .05LT 5 layer scan head jumps to y=0.lbrn (1.0 MB)
LT 5 layer scan head jumps to y=0.lbrn (1.0 MB)


(system) closed #2

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.