ok
Starting stream
Stream completed in 0:00
<Idle|MPos:200.000,215.000,0.000|FS:0,0|WCO:0.000,0.000,0.000>
ok
Starting stream
Layer 20% Pass 1 of 2
Layer 20% Pass 2 of 2
Layer 20% Pass 1 of 2
ALARM:2
On or near line 4:
Stream completed in 0:00
[MSG:Reset to continue]
ALARM:2 : “G-code motion target exceeds machine travel."
You tried to move the machine outside of its working area and it kept you from doing that. Show a screen shot of your LightBurn window with the design and the Laser window visible.
That information helped! Thank you.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.