Homing cycle not enabled

Larry4 · April 27, 2024, 4:48pm

where to find grbl settings

berainlb · April 27, 2024, 4:49pm

Check this site for reference:

gnea/grbl/blob/master/doc/markdown/settings.md

## Getting Started

First, connect to Grbl using the serial terminal of your choice.

Set the baud rate  to **115200** as 8-N-1 (8-bits, no parity, and 1-stop bit.)

Once connected
 you should get the Grbl-prompt, which looks like this:

```
Grbl 1.1d ['$' for help]
```

Type $ and press enter to have Grbl print a help message. You should not see any local echo of the $ and enter. Grbl should respond with:

```
[HLP:$$ $# $G $I $N $x=val $Nx=line $J=line $SLP $C $X $H ~ ! ? ctrl-x]
```

The ‘$’-commands are Grbl system commands used to tweak the settings, view or change Grbl's states and running modes, and start a homing cycle. The last four **non**-'$' commands are realtime control commands that can be sent at anytime, no matter what Grbl is doing. These either immediately change Grbl's running behavior or immediately print a report of the important realtime data like current position (aka DRO).

This file has been truncated. show original

Focus on $22.

system · May 27, 2024, 4:49pm

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.