Homing error5 with Longer Ray5 laser

LightBurn Hardware Compatibility GRBL
1

Below are the error response when setting up Longer Ray5 , LightBurn 14.01 on a Dell Desk Top D0H4SL1. Have turned off “AutoHome at Start Up” in Edit and checked settings in “Devices” under LASER window. Please help!

Waiting for connection…

ok

[VER:1.1.2022010301:]

[OPT:PHSW]

[MSG:Using machine:LGT RAY]

[MSG:Mode=AP:SSDI=MKS_DLC:IP=192.168.4.1:MAC=B8-D6-1A-9D-82-ED]

ok

error:5

Homing cycle is not enabled in your Grbl settings.

Waiting for connection…

ok

[VER:1.1.2022010301:]

[OPT:PHSW]

[MSG:Using machine:LGT RAY]

[MSG:Mode=AP:SSDI=MKS_DLC:IP=192.168.4.1:MAC=B8-D6-1A-9D-82-ED]

ok

error:5

Homing cycle is not enabled in your Grbl settings.

2

Double-check the Auto-home on start up switch in Device Settings. It’s easy to overlook the OK button and not confirm/complete the change.

This may be the auto-reset that LightBurn sends to the controller.
This should disappear once the auto-homing is off.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.