Homing not working correct

LightBurn Software Questions
1

Strange issue in homing on my Mini Gerbil. Might be easier to watch the video I recorded:

http://f.cl.ly/items/2d0s45441R0N2A343K2c/IMG_5101.MOV

edited to fix link to video

Essentially, once it hits the Y axis limit switch, it stops moving towards the X limit and does it’s little bounce thingy. If I start the head closer to the X limit than the Y, it will hit the X switch and then continue along the Y as expected.

As I noted in the video, I’m not sure if this behavior is the Mini Gerbil or the software (Lightburn). Anyone have a similar issue?

3

LightBurn just sends the command to the controller and the controller handles it from there, so it won’t be a software issue. I’d check with Awesome Tech to see if they have suggestions - it could be a firmware or wiring issue.

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.