Hello everyone, our company is engaged in the production of marking boards, similar to Basili and Jinchengzi. Our boards are based on ARM+FPGA architecture. ARM processes graphic data, and FPGA controls the galvanometer and laser. How does LightBurn control our marking boards? What protocol is required?
Your best bet is to contact Support@lightburnsoftware.com along with specifics about your design intent and hardware.
In short, LightBurn communicates with GCode, DSP, EZCAD 2 and BSL lasers. You’ll want to support one of those firmware protocols.
A post was split to a new topic: Help needed with LightBurn
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.