I have a Creality CR-10 Laser falcon. I purchased an Ortur Rotary chuck (because i also have an Ortur LM2 pro S2). When installing the rotary chuck it instructs you to turn off homing ($141=600) but when i removed the rotary i could not figure out how to turn homing back on. when i tun on the laer it will connect to lightburn but then gives me a alarm 9, alarm 3, and if you hit frame it goes to busy and never does anything.
i hit $# and got the following as well as $$ which are attached below.
$#
[G54:0.000,0.000,0.000]
[G55:0.000,0.000,0.000]
[G56:0.000,0.000,0.000]
[G57:0.000,0.000,0.000]
[G58:0.000,0.000,0.000]
[G59:0.000,0.000,0.000]
[G28:0.000,0.000,0.000]
[G30:0.000,0.000,0.000]
[G92:0.000,0.000,0.000]
[TLO:0.000]
[PRB:0.000,0.000,0.000:0
ok
$$
$0=10
$1=250
$2=0
$3=4
$4=0
$5=0
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=1
$21=1
$22=1
$23=3
$24=1500.000
$25=4500.000
$26=20
$27=3.000
$30=1000.000
$31=0.000
$32=1
$100=80.000
$101=80.000
$110=10000.000
$111=10000.000
$120=500.000
$121=500.000
$130=400.000
$131=415.000
ok