Is it possible to have the framing run on a slight delay? I have my laser on the other side of the room and was hoping I could have the delay start a few seconds after it is pushed. I plan to setup a camera at some point but in the meantime this deal would be helpful.
As an intermediate solution, you could draw a shape (a spiral for example) on its own layer with 0% power. It should be the first layer in the order.
Not at the moment unfortunately. We have a task partially finished that will run the frame continually until stopped, but that’s not going to make it into the pending release.
That would actually be WAY better then the delay! Love the idea and looking forward to seeing it in the product. Thank you.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.