Hi All
Just wondering if lightburn will work with a Thunder Laser DF212 controller in an older MARS 90 machine.
I don’t seem to be able to make it work but that’s me and computers in general
Thanks in advance.
Regards
Graeme
Hi All
Just wondering if lightburn will work with a Thunder Laser DF212 controller in an older MARS 90 machine.
I don’t seem to be able to make it work but that’s me and computers in general
Thanks in advance.
Regards
Graeme
This lists all supported controllers for lightburn.
MODEL:DF212
CO2 DSP Laser Controller —THUNDERLASER
DF 212 is an independent DSP laser controller used for the laser cutting and engraving systems.
Since it’s ‘an independant dsp’ and not on the supported list, I would assume it would not.
Good luck
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.