Hello. Please help me. I have a lazer sculpfun 9s. I downloaded lightburn software on a official site for a month (free). This program is great and I would like to buy a license key after month. But what is issue… The laser don’t off when i press a button ‘‘pause’’. He stop and countinues to burn a materials on one point. And don’t off when cutting two different figures. There is a line between them. May you help me with this issue, or give some advice? Thank you and have a good day
Seems like you did not enable the laser mode. Check if firmware parameter $32 is set to 1 ($32=1). You can check out how to configure your system here: Setting up the software - Diode Laser Wiki
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.