Hi
I’ve been using lightburn with my old pc with no problems. However I have now got a new pc using lightburn working with the same machine but now I’m having problems when sending code.
The machine starts, mable moves two or three times, stops and then I get the following message:
G-code words consist of a letter and a value. Letter was not found.
On or near line 28:
Job halted
Stream completed in 0:00
error:2
Numeric value format is not valid or missing an expected value.
ok
error:2
Numeric value format is not valid or missing an expected value.
ok
ok
ok
ok
ok
ok
ok
How can I over come this? Thanks in advance
Nathan