Issue with engraving circle start and stop

I’ve attached a picture of the result I’m getting with a circle cut on my tile. It looks like the laser has not turned on fast enough and the X & Y starts moving too quickly. I’ve tried adding a delay and that hasn’t helped. I also tried overcutting by .02" and that hasn’t affected anything either. I am using a Z offset of .035" in and I wonder if that has an effect on the result. Does the start time delay happen after the X & Y rapid to position and just before the Z moves down to start lasering?20201109_093230|375x500

I just found out that the machine is doing overcutting like requested but it does not show that in the preview pane. A .01" overcut seems to have solved the open circle problem.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.