# Issue with G code

**URL:** <https://forum.lightburnsoftware.com/t/issue-with-g-code/191948>\
**Category:** LightBurn Software Questions\
**Created:** [August 19, 2026, 4:31pm UTC](https://forum.lightburnsoftware.com/t/issue-with-g-code/191948 "2026-08-19T16:31:44Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![happyroundman](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/h/ec9cab/32.png) [@happyroundman](https://forum.lightburnsoftware.com/u/happyroundman)\
**Post date:** [August 19, 2026, 4:31pm UTC](https://forum.lightburnsoftware.com/t/issue-with-g-code/191948/1 "2026-08-19T16:31:44Z")

</div>

I have never had this issue. I have not used the software for a couple of weeks. I fired it up and started my first project. I used Imag-R to set up a photo for engraving which I have done many times over the past several years. Got it downloaded and set up to engrave. It stops before it even atempts to engrave and the console says there is a G code issue. I re downloaded it and I had the same issue. I went back and tried to do a project that had already been finished and delivered. I had the exact same problem. I have savd the console information and can provide it if needed. any help would be greatly appreciated

---

<div class="post-metadata">

**Author:** ![fins](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/f/87869e/32.png) [@fins](https://forum.lightburnsoftware.com/u/fins)\
**Post date:** [August 19, 2026, 6:24pm UTC](https://forum.lightburnsoftware.com/t/issue-with-g-code/191948/2 "2026-08-19T18:24:10Z")

</div>

Go ahead and post the console output; not much to go on otherwise.

---

<div class="post-metadata">

**Author:** ![MikeyH](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/m/43a26b/32.png) [@MikeyH](https://forum.lightburnsoftware.com/u/MikeyH)\
**Post date:** [August 19, 2026, 7:05pm UTC](https://forum.lightburnsoftware.com/t/issue-with-g-code/191948/3 "2026-08-19T19:05:51Z")

</div>

Ditto.

Did you accidentally turn on the **Enable Gcode Clustering** switch?

Are you seeing any error message reported in the Console window?

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [September 18, 2026, 7:06pm UTC](https://forum.lightburnsoftware.com/t/issue-with-g-code/191948/4 "2026-09-18T19:06:05Z")

</div>

Closed on September 18, 2026, 7:06pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
