Issues with setting the Z Height after Focusing

[CrazyworX (Namik Tezer)]

Hi Guys,
I had to change my Laserhead. Realized that now the height is different. I figured out also the Distance where its Cutting properly, but I am not able to set the Height anywhere that its starting always from that height after focusing.
How can I set this Parameter and where? Can I set that over Lightburn or in do I have to set it in Ruida Controller?
Appreciate the Help!

[jkwilborn (Jack Wilborn)]

This is out of my real area, but I assume you use the Z axes for the focus switch?

There is a ‘home’ entry, I assume for some kind of offset, for the Z in controllers Z axis setup.

[berainlb (PY)]

This topic may be related. See if this helps:

Autofocus Adjustment on Omtech

Hi, I recently purchased my 100w Omtech laser, after a few months of using it i discovered i had not been cleaning my lens as often as i should of been which resulted in having to buy a new lens. I bought the same one that was stated in the manual. Replaced the lens only to find that my focus is now totally out. I have autofocus with this machine, i was advised to do a ramp test and found my optimal distance from the bottom of my laser head but i am having trouble adjusting the autofocus to get…