Jaw chuck rotary help

Rotary setup help! Chinese 60w red and black laser. I have hooked up my jaw rotary attachment. 1. I have turned off Y-axis homing 2. Enabled rotary 3. Left the steps at 10,000 and imput my diameter of my working piece. I also decreased my idle to 50.

When I draw a square for a test run. The preview shows that it will work. I hit start and the machine just beeps. Any input would be greatly appreciated! I’m sure I’m just missing some steps.

When you look at the controller’s screen on the machine itself, what error message does it display?

I will try it all again tomorrow and let you know the results. Thank you for replying!

It is not showing any errors. Just says done

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.