I am a manufacturer of machines with JCZ electronics. I would like to start using and offering all my machines with Lightburn software instead of Ezcad2. However, when doing the tests with the software, one of the parameters that I did not find and I need a lot, is the automatic Z axis, which the JCZ board offers the control and the Ezcad offers the use in such a way that I put the height of the recording face and it automatically raises and lowers the focus.
Where do I do this Z-axis parameterization in the software?
As far as I know, this is an EZCad3 operation and not supported by Lightburn.
Lightburn only supports EZCad2 compatible boards.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.