Just switched computers, getting a error 9 and alarm

I just switched computers to be closer to the laser cutter because on my other computer it would get to the location to engrave then disconnect and reconnect and rehome and wouldn’t engrave. Now on the computer closer to the laser cutter it will get to the location, engrave one side of a keychain I’m trying to make, and then gives the error. causing this error? I looked up the error 9 and it came up with a homing cycle error but it homes just fine. Im using a mini gerbil with lightburn.

error:9
<Alarm|MPos:100.108,114.331,0.000,0.000,0.000|FS:0,0|WCO:0.000,0.000,0.000,0.000,0.000>

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.