I just installed a MiniGRBL 1.1f and LightBurn 9.02. I start the job and it runs for a little while and them the job ends with error 1 or error 2 or error 24. I am using Grbl-STM for the device.
Any thoughts?
I just installed a MiniGRBL 1.1f and LightBurn 9.02. I start the job and it runs for a little while and them the job ends with error 1 or error 2 or error 24. I am using Grbl-STM for the device.
Any thoughts?
I have a Mini Gerbil on my K40 and haven’t had any problems at all. Can you give us some more details about the cut job?
The only thing I could think of is a power issue causing the Gerbil to hiccup (K40 power supplies are notoriously bad) but that’s just a guess…
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.