Laser burn from top instead of bottom

[alienkidmj12 (David Sives-Rutherford)]

i am doing a halftone image, only problem is that half way it stopped burning due to power. is there a way i can start again but do it from the opposite side, i know it will probably not match 100% but atleast ill save most of it.

will this do it - optimisation settings / cut in direction order / from top ?

thanks

dave

[HumptyDumpty (Tim S.)]

Not sure if this is the best way to recover or not but you can scan from top down by changing the Scan Angle in the Cut Settings.

[alienkidmj12 (David Sives-Rutherford)]

thanks ill give that a go on some test wood