Laser cuts out after update

Hi all,after a few weeks of playing, and getting some fairly good results, apart from photo/grayscale on my basic 7w ortur master, I did the firmware update…now it runs for a few seconds, burning well ,then cuts out…no alarms…
Any ideas???

Thanks for posting and welcome. I would like to point you to the search, found at the top-right of every page to help you find subjects that may have already been covered. Faster, self-serve approach for stuff that comes up often.

https://forum.lightburnsoftware.com/search?q=ortur

Have a review of these topics as a good starting point.

1 Like

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.