Laser "disconnected"

Just installed the software on Mac OS 10.13.6 and used the auto-detect feature for my Millright Carve King with 2.8W Jtech laser. The device shows a GRBL 432mm x 432 mm at cu.usbmodem14… and asks if this is a shapeko/x-carve or other. I selected “other” but the dialog for laser always shows “disconnected.” Noob question but I’m stopped before even starting…

Under Edit/Machine settings it says “communication with controller failed.”

Have you selected the port here?

image

Thanks missed that!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.