When I do Scan recordings I notice differences in the model I’m recording.
In most cases, the entire end (of the X axis) is burnt more than the rest. In the photo below I made two recordings. The upper recording has the option “Constant Power Mode” disabled. the lower recording has “Constant Power Mode” enabled.
Of course, you can notice more intense burning with “Constant Power Mode” enabled, but I would like my recording to look the same without burn variation.
Has anyone had this problem and managed to solve?
Perfect Rick.
He was looking for something like that, and you brought the light to earth.
Thank you very much
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.