Laser does not want to home Grbl ‘$’ command cannot be used unless Grbl is IDLE. Ensures smooth operation during a job

Good day

I just put my laser cutter Ortur master 3 on and it does not want to home. I want to start cutting and engraving but it gives me this error Grbl ‘$’ command cannot be used unless Grbl is IDLE. Ensures smooth operation during a job.

The laser is not moving. Light burn is picking it up but does not want to home.

I would right click device in laser window and reset controller.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.