Laser firing on move/traversal path that does not exist in Alt+P Preview or file

[ednisley]

@SF_Jenn

sending the file once more to the laser via the “Send” button

This seems as though the file is damaged in transit.

If you’re connecting the PC to the Ruida over USB, switching to Ethernet will eliminate a whole bunch of jank.

However, the Ruida has a fixed / static IP that must be out of the range where the router on your LAN assigns addresses using DHCP.

Some previous discussions may explain what’s going on:

Hello fellow laser wizards

HELLO, I have a tech problem. My Omtech AF2028 stopped communicating via ethernet. I replaced the cable and still having message, Data not transferred, controller busy or paused. checked IP Adress and replace cable USB connection works fine my modem and hub is fine suggestions are seriously appreciated Bob

Losing position at end of job

I’ve just spent a long time upgrading an old machine to a Ruida controller + lightburn. Almost everything now seems to be working, happy days. One thing that is occurring which I cannot seem to resolve is that during complex jobs there often seems to come a point where the controller seems to lose position. A good example of this is a recent cut I did where in one layer in light burn I have a circle with leaves and vines and chains, etc some complex geometry. All gets cut quite well. In the nex…

Transfer failed pop up

I keep randomly getting the transfer failed pop up. The job starts, the pop up pops up, it will engrave/cut for however long it decides to and will just stop in the middle of the job. The laser says it’s ready. Next time I run the job the pop up may or may not pop up again. It’s getting really frustrating trying to get jobs done. What are things to try? I have restarted Lightburn multiple times.