Laser hits side and back walls when going home

I recently got an XTOOL d1 pro 10w and it’s been working great until 2 days ago, I found out that my limit switch was not fully connected- it’s been working sense. Today again, the same issue occurred yet all switches are in place. When I send my laser home it heads left and hits the railing, vibrates (it sounds horrible) and then slides back but then hits the back railing and does the same thing. I’m not sure if it’s a setting I need to reset or look into, or if it’s on the machine. I am cluesless as I’ve only had the machine for about a month.

Does it exhibit the same behavior in the Xtool Creative Suite ?

I do not know, I’ve never used that software. I can try it

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.