Laser is working but not engraving. Please help!

I’m working for some time now on my Ortur LU1-4 laser master 2 and for a couple of days, it starts engraving, it completes the project and I cannot use it again and I have to come back the next day to create something else ( which of course is not guaranteed!)
Is there something wrong with the software? Do you need extra info from me?
My $32 is “true” and $30 is 1.000 (I have previously checked other posts non of which is helping)
My Lightburn software is “LightBurn 1.0.06”

Just an observation from your post, which may be a typo but $30 should be 1000 not 1.000, the S-value max setting under device settings should also be 1000

1 Like

I agree.

I switched my language to French because I wanted to see if the comma would be in place of the decimal point as it is in several languages. In English 1,000 = 1000 but in French 1,000 = 1.000

The Machine Settings menu uses English Language number formatting.

In Edit - Machine Settings, I was unable to enter the decimal point for the setting in $30 so typing (1.000 became 1000) and entering the comma (typing 1,000) made the $30 = 1000.

In the Console window, if I type $30=1.000 and then verify the settings by typing $$, the $30=1. If I type $30=1,000 in the console window my GRBL controller rejects the command.

1 Like

Screen Shot 2022-05-01 at 6.19.26 PM

i meant 1000 hehe :slightly_smiling_face:

Open the Console window in LightBurn and type the following:
$$
then press enter.

Please verify that $30=1000 as well.

Any messages shown in the Console window may be of help.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.