I have been burning very successfully including this morning. I tried a new project this afternoon and now the head moves very erratically (jumpy) and when I try to frame it moves in random directions in no consistent pattern. If I try to print it says it might be outside the print limits, but print is in center of grid. I have reloaded software, and had the software find the printer. Also up to this point to printer found was called GLBR but now it says GRBL-M3 (1.1e or earlier). Help!
a reboot of both computer and laser usually resolves my issues of erratic behavior
How do you reboot the laser? I am new to all of this. I did unplug it and plug back in. Thanks.
just shut it off and turn itback on so it goes through a homing cycle
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.