Hello everyone, I have tried to search for my answer and come up short, I am wanting to use Lightburn on my Sculpfun s6 pro, this is the 5.5w, I can get it to engrave just fine using the laser grbl software, But then tried to use the Lightburn and get basically no burn/cut Laser does move and acts like its going to engrave just fine just does not actually do anything with the burn, I assume it is a speed and power setting issue however I have no idea what they should be at, this is my first laser as I just wanted to dabble in it, Any advise is greatly appreciated
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.