I’m new to this so perhaps I’m doing something wrong but several times I have had to restart because the laser will travel past the jobs frame, may fire and may hit the limit switch. I’ll watch the travel and it sometimes continues fine or it may stop after limiting to the machines edge. Any suggestions welcome!
Move the work piece out towards center of work area.
Thanks for your suggestion. The workpiece is in the center with the framed job about 2 inches away from both sides. The laser just moves all the way to the side, beep and stop. Luckily I’ve found how to restart close to the previous spot. Looking for why the laser head goes so far past the edge, freezes and shuts down.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.