Laser stopping a 1/4 way through

hello, i am new to light burn and its been a learning curve. I am trying to to do a test run by creating a coaster. I am successful within the first five seconds of the engraving and then the laser seems to cut its power. The engraving still runs and the laser does seem to be on; however it engraves 2% of the job and continues running the program.



heres a pic of the simple program i am running and the result. any suggestions on what might be happening here?

Do you see any error messages in the console window when it stops?

no i didnt, i changed the path count back down to 1 and increased the power. Now i am moving and grooving. Thank you for your help; knowing me and my luck i will be back here shortly to annoy you once again
Alex

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.