Laser stops and beeps twice -- Restoring Spindle Message

LightBurn Hardware Compatibility
1

I recently set up my new Falcon 2 laser and on one particular file for a slate coaster it will randomly stop and beep twice. I have to pause and resume to get it going again and it may do it again right away or later. Also since setting up the new laser, the Job Status bar starts fully green and at 99%. After I resume the Console tabs has [MSG:Restoring spindle]

Ive burned other designs on slate coasters with no issues.

My S/P is 700/25.

Has anyone experienced anything similar? It’s annoying, especially with 350 coasters to do.

UPDATE: I just created the file from scratch and its doing the same thing.

2

Could you post your .lbrn2 file?

3

I figured it out. The laser was tripping the limit switch. It was an easy fix once I figured it out.

1 Like
4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.