Laser will not cut off

LightBurn Hardware Compatibility Ortur Lasers
1

Newbie here. I am attempting to pracitce in setting up my newly purchase Ortur Laser MAster 2 - 20W. When i engrave anything, the laser will not cut off. Even if it goes back to home position, it will set there and burn a hole.

Is this some seeting i have wrong or something wrong with Lightburn. I have the most recent update for Lightburn.

2

This is most likely a dead board in the Ortur. They had a batch of them that were bad. Open a ticket with Ortur Support and they’ll have you run a couple tests and likely replace it for you.