LB 2.0.01 Air assist stops during cut

LightBurn Software Questions
, , ,
47

@TrajoMarx If willing, can you do the following to rule out a hardware fault and to give us more infos for troubleshooting?

  • Right click in the Console Window, select “Clear Console” and enable “Show All”:

    image
    image996×379 15.4 KB

  • Enter these commands, one line at a time, and press “Enter” after each:
    $i
    $$
    $#
    ?

  • Enter M8 in the command box and press Enter. - The Air assist should turn on.

  • Entering M8 again, it should stay on as far as I’m concerned.

  • Let it run for a couple minutes. - Does it stay on?

  • Enter G1 S0 and press enter. - Nothing should happen. (Jon already asked for this part, but I’d like double-check.)

  • Finally, enter the M9 command to turn the air assist off.

The air assist should stay on until the M9 command is sent. Kindly let us know, if it behaves otherwise.

Then, right click in the console, “Select All” and copy/paste the full output in a reply here.